IOT : Accelerate your research using NetSim C libraries

IOT_Scenario_Blog-01
Research areas in IOT
  • Seamless integration of heterogeneous devices
  • Network architecture for IOT
  • Energy management and sustainable operation of IOT
  • 6LoWPAN based IOT design
  • Modeling and simulation of large scale IOT network
Write your own code
  • Create custom protocols using NetSim’s simulation API’s
  • Interface with other software products like MATLAB
  • Debug your code (step-in, step-out, step-over, continue) and watch your variables in sync with simulation
NetSim IOT features
  1. Create scenario , simulate and observe the performance of 6LoWPAN network
  2. Devices: Sensor Motes, 6LoWPAN Gateway, Routers, Switches, AP and Nodes can be used for the scenario building and simulation
  3. Data Link layer: Unslotted CSMA/CA, Slotted CSMA/CA, CCA
  4. Physical layer: Received Power Calculation, Fading, Shadowing, SINR calculation, BER calculation, Collision and error checking
  5. Sensor Mobility model, Sensing parameters, Packet generation, Packet Reception
  6. Radio Energy and Power Management
  7. Network layer can run both on IPV4 and IPv6
  8. Routing via AODV (RFC 3561), OLSR (RFC 3626), ZRP
  9. 6LoWPAN gateway will switch the packet from one network to another
  10. Facility to conduct various experiments for differing input / output parameters
  11. Input: Beacon Order, Super frame Order, Back off Exponent, Power Consumption, Battery life extension, CCA type, Receiver Sensitivity, ED Threshold, Channel Characteristics
  12. Output: Routing Overhead, Delay, Power Consumption, Lifetime of motes, Packet Delivery ratio, Routing Time, Actual Vs. Sensed path of agent

Comments are closed.